|
Cedar Bluff, AL | Yes thats what I thought about doing after I had already updated that last thread. What my plan is, Connect the clutches to circuits 3,4,5 and 6. And place jumpers in rows 1,2,7&8. On the CAN Switches leave switches F2&F3 off and assign switches F4 thru F7 to my 4 rows and leave switches F8 thru F10 off. I'm thinking if I can configure 8 rows at 19 inches instead of 8 rows at 38 inches that would keep my swath width the same as 4 rows at 38 inches. Do you all think this setup will work. TIA. | |
|