|
Nebraska | I am only a rookie with the AgLeader equipment but I don't think it is the cable. I was able to configure a 1/2 width disconnect (2 clutches or relays in my case controlling the hydraulic drives) with a 2 row per section 8 section cable. I only used wire #2 and #3 of the round amp connector I think. #1 is 12 volt. My response is all from memory so my be completely incorrect but I think your cable will work as long as you get the clutches connected to the correct wires. My cable was a 2 row per section cable not sure if that will make a difference or not. | |
|