|
SE NE | Here are some picture of the configuration and the Auxiliary Input Diagnostic. I think everything look to be working correct, the switches change from black to green when I flip the switch.
What I did figure out list nigh is if I have the master switch on and my 4 section switches on it show all the section green and I can turn the section switches off and the sections go back to a thin red bar. BUT when the section are on there is air to the clutches. I pulled the airlines loose to check this and when a section is on there is definitely air to the clutch. So like I noticed before when the section are active there is no seed flow.
I checked all the wiring with the wire harness drawing and everything looks correct.
The implement switch is a push button normally closed switch and so when the planter is down the button is un-pushed and the is continuity through the switch.
It just seems like the air flow to the clutches is complete backwards of what it should | |
|