Near Intersection of I-35 & I-90 Southern Mn. | I assumed your planter is ground drive. The legend to the right seems to show that you are looking at an application view. This is what would be seen with hydraulic drive through an Ag Leader hydraulic drive module. I see a screen like that when I view my spray system which is also on my planter.
I believe you may have setup the configuration incorrectly. Are the only modules connected the Auxiliary Input module in the tractor, the STTM and Clutch Control Module on the tractor?
Please follow my suggestions of above and post a picture of the input diagnostic screen. That is the one with the boxes that can be gray, black or green. Also go to the switch assignment page and post a picture of that screen. That is the one that describes which switches are doing what. This should be very helpful.
Edited by tedbear 4/28/2021 08:35
|