|
n.c.iowa | The difference being this; in the parallel system I ran a 3/8’s line down the bar and tapped off in front of every row unit, typical parallel system.
For the manifold part I built 2 manifolds out of 4 inch seamless pipe, each feeds four rows, there is a 1/2” pipe connecting the manifolds with a 3/8” feeding the row units.
The manifolds are directly in front of the rows.
My thought was that I could vary air pressure by section if I thought it was needed, and was kinda experimenting with some ideas I had. | |
|
Fieldview cab margin map
