|
| Look for dip switches in small box hanging from harness under seed hopper (have to take cover off box to get at dip switches), setting these in increasing increments will contol hydraulics and tool bar hieght. Because of repeatability issues, we set switchs to lowest setting and then made ram stops for desired toolbar height. All planters with this setup I've seen have used this fix as a permanent fix. The box is not very big. Its been too long to remember switch settings, but try setting all "on" or all "off" . One of those setting should be full down.....I think. Some experimenting should work. Good Luck. | |
|
Need help with 800 cyclo.
