Jim,

I haven't had any problems since the initial run. I tightened all of them after I lost the two. There were a few that were a little loose. Quite possible that they were loose on arrival. We never checked them. I guess I should have. What are the proper steps to take on rebuilding the wheel that has a loose bearing?

I had a unit hit a hole tonight and broke the pipe going into the top of the GFX. I didn't think they would travel that far but it had to have hit the air bag mount. Can RDO make me one of those hoses? I don't think our local shop will have a fitting like that. I was just going to sugges that you use a 30 degree fitting rather than a 45 so it didn't pull on the hoses so much, but I retract that suggestion after seeing that.