Stoddard Co. SEMO | roddfarms - 5/14/2022 22:45
So the picture I showed from the Steiger manual, using a 1/2" round bolt to judge the distance between the rear of the clutch release bearing and the clutch brake disc.
Did you do that ? Do you have 1/2" distance there? If you have more than that, the clutch needs internal adjustment yet.
If you have 1/2" and it still don't work, its linkage or malfunctioning hyd master/slave problems.
Troubleshooting 101
I had greater than 1/2” so I rotated the clutch clockwise to decrease the distance. Should I have rotated it counterclockwise instead? Because the clutch brake has wear on it, I have been using clutch brake shims.
Edited by D&M Farms 5/14/2022 23:16
|
Steiger panther clutch adjustment
