Viewing a thread - 925F building up on cutter bar. Any suggestions?

You are logged in as a guest. ( logon | register )

925F building up on cutter bar. Any suggestions?	View previous thread :: View next thread
Forums List -> Machinery Talk	Message format

Tractor Jockey

Posted 12/6/2018 16:59 (#7153585 - in reply to #7153467)
Subject: RE: 925F building up on cutter bar. Any suggestions?

Walla Walla, WA

Mike is right. Auger should just clear the rear stripper. Auger height is normally set using the finger, Approx 5/8 inch above the floor when it is straight down. Paul

925F building up on cutter bar. Any suggestions? - BronsonA2150 : 12/6/2018 15:40
- RE: 925F building up on cutter bar. Any suggestions? - Bullfrog : 12/6/2018 15:45
- RE: 925F building up on cutter bar. Any suggestions? - Mike Aylward : 12/6/2018 16:02
  - RE: 925F building up on cutter bar. Any suggestions? - Tractor Jockey : 12/6/2018 16:59
    - agree on the stripper plate clearance - dvswia : 12/6/2018 20:00
      - RE: DIFFERENT OPINION on the stripper plate clearance - crowbar : 12/6/2018 20:34
        
        RE: DIFFERENT OPINION on the stripper plate clearance - dvswia : 12/7/2018 06:03
- RE: 925F building up on cutter bar. Any suggestions? - H8toW8 : 12/6/2018 16:33
- RE: 925F building up on cutter bar. Any suggestions? - lugnut56 : 12/6/2018 17:40
- RE: 925F building up on cutter bar. Any suggestions? - NEMOScott : 12/6/2018 18:08
- RE: 925F building up on cutter bar. Any suggestions? - PatCMO : 12/6/2018 18:41

Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)