AgTalk Home
AgTalk Home
Search Forums | Classifieds (109) | Skins | Language
You are logged in as a guest. ( logon | register )

925F building up on cutter bar. Any suggestions?
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Tractor Jockey
Posted 12/6/2018 16:59 (#7153585 - in reply to #7153467)
Subject: RE: 925F building up on cutter bar. Any suggestions?


Walla Walla, WA
Mike is right. Auger should just clear the rear stripper. Auger height is normally set using the finger, Approx 5/8 inch above the floor when it is straight down. Paul
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)