|
Guelph Ontario Canada | BHTN - If you have the wedge box plugged in, without a receiver on the harness it is going to cause many of the errors that you described. No data is recorded to cards without being tied to gps data. The display is going to complain about no signal / gps because the wedge box is telling it to look for one that isn't there. You get a mismatch error because the system is wanting to yield monitor because there is no receiver and the processor wants to map. Unplug the processor and your errors messages will likely go away. You may have to dig deeper on the variable readings by cleaning and inspecting the components. With the processor unplugged you should be able to assign numbers to fields and use a data store module to get the totals off if your dealer has one.
If you want to save data to cards and map, the cheapest solution for you would be to find a used original starfire receiver that is "dual can". (Since you have the silver wedgebox your combine is 4/5 volt and will have to be updated to work with newer components). Plug that into the mix, plug your processor back in, update the software, throw a data card and you should be ready to go. Setting the card up in jdoffice would be benifical.
| |
|