|
East Central, Nebraska | i have also used agleader for a number of years. i cannot remember though it seemed to me i have not had to cut holes in the side of the elevator for a couple models and also that i had one or two deere models that did not need the holes cut in the top also. that could possibly have been because the previous owner used agleader or maybe deere and agleader sensors were pretty consistent in those years. one thing is for sure agleader has kept with a similar design over the years.
i have moved up different models from the 00's. its hard to remember what i had to do for each to make the moving equipment possible. i have little to no experience with the s series.
install guides can be found on agleaders website under support. | |
|
What would I need for yield mapping on 9670 combine?
