|
| Finally did the wiring today.
Under the buddy seat there are 2 nuts and 2 bolts to remove (circled in red). That allows the fuse panel to come up.
Then you grab the 40 pin connector. Circled in red is the half that needs to be modified (assuming I did it right).
I just cut the two wires and butt spliced and heat shrinked them.
I have not used it yet. We'll see how it goes.
Edited by dpilot83 4/3/2018 14:56
(3CFEE1E6-C897-415B-B5CC-F2CC1BD287B6.jpeg)
(5FDA1044-4867-428E-A642-F9E1DA164C4D.jpeg)
(42C4A945-5363-44B1-9414-D60F63CDCB43.jpeg)
(B0E9A356-7E76-4AB8-BFE0-F22F4BF1F9DA.jpeg)
Attachments ---------------- 3CFEE1E6-C897-415B-B5CC-F2CC1BD287B6.jpeg (152KB - 75 downloads) 5FDA1044-4867-428E-A642-F9E1DA164C4D.jpeg (114KB - 76 downloads) 42C4A945-5363-44B1-9414-D60F63CDCB43.jpeg (101KB - 80 downloads) B0E9A356-7E76-4AB8-BFE0-F22F4BF1F9DA.jpeg (90KB - 77 downloads)
| |
|