|
South Georgia | I guess you're right, I hadn't used PWM input yet, but I do remember reading that it would just be read as a voltage. I guess you'd have to put a capacitor between the terminal and ground to smooth the signal out. In that case, I guess the coding is the same either way, so this whole discussion is irrrelevant. (Like a lot of my conversations!)
I'm pretty sure that the sensors also output both PWM and analog, depending on which pin you read, so it's not an either/or situation from the hardware side, either. Unless I misunderstood when I was looking at the spec sheets.
Adrian | |
|