|
SE SD | Trimble 500. BT-232B-E bluetooth serial adapter. Lefebure NTRIP connects to the serial adapter. NTRIP is receiving RTCM3_MAX data stream from Iowa CORS.
Serial adapter is set to DTE which transmits on pin 2 (500 receives on pin 2). Not sure how to set Slave/Master and group enable switch. I left the default settings of 19200, Parity None and Stop Bits 1. I set the 500 RTK generic CMR radio to these settings.
I need to use NMEA out the aux of the 500 to feed the planter/sprayer monitors. So I am using Android GPS on NTRIP.
The 500 isn't getting RTK. I've seen recommendations for higher baud rates. Would this fix it? I would have to download setup software for the serial adapter and try to change it. I did try all of the baud rates on the 500 but none worked.
 (Screenshot_2019-05-01-14-22-46.png)
Attachments
----------------
 Screenshot_2019-05-01-14-22-46.png (179KB - 107 downloads)
| |
|
setting up BT serial adapter on Trimble 500
