Posted 4/16/2018 21:00 (#6714328 - in reply to #6712637) Subject: RE: Trimble Roll Calibration
If you were having trouble last year, belt you start you need to make sure the screws that hold the nav controller to the mounting plate are tight, and also make sure the mounting plate is mounted tight. I had one that the (single) bolt holding the mounting plate had backed out and was letting the Nav bounce around. It was NOT good.
What county are you in? When y'all going to start planting some peanuts? I'm in Mitchell county, I know of a few planted last Friday. We may start later on this week.