You can generate application reports on the InSight. This only works for "application" operations. There are 2 ways to do this. From the main run screen you can select the "Field Notes Tab". In the lower right corner there will be a "reports detail button." This button will take you to a screen where you can enter application conditions and generate the report. I am not sure if you can generate the report after you copy to the card, but I suspect you may be able to. You can also set the monitor to auto generate the report. From the main setup screen, select the "field notes button", (left side). Then select the "reports" tab. Check "auto generate reports" and "prompt for report details". Everytime you start an operation you will be prompted to enter the report details. When you end an operation (change to a new field) a report will be generated automatically. The reports are stored on the card. Look in the monitor folder (the one with the monitor serial number for a name). If you have generated any reports there will be a sub folder named "reports". Again, this only works on application operations. It will not generate planting or harvest reports. |