|
Leeds, North Dakota | Very possible worn or broken shift fork, cam roller could be bad on rail, possible shaft is moving in case, pivot tractor all the way to left, clean rear of transmission off on r/h side, will see three appx size one inch shafts that should be flush with case. They will be to the left of cover on r/h side running vertical, as you shift thru the gears watch and make sure these shafts due not move, if they don't need to remove seat and floor board, drain tranny and remove cover. Two people make life alot easier, not alot of room in there, Scott. | |
|
875 shifter problems
