|
| For an agleader to work with an IFC100 Krohne converter (box on top of flow tube) turns out you need a 20K ohm resistor from +12volts to the D pulse output then the flow cable connects to the D and D- (white and shield respectively). Agleader is coming up with a harness will this all in place, but I'm not sure if it replaces one of the raven harnesses or is just a power/signal harness for the flow meter.
It's really great to finally have the flow control system working right. Generally speaking it stays just about right on target unless some solids go through the pump and mess with the flow a little.
Thanks for all the help,
Pat
PS: the guys at stutsman's where a huge help. | |
|
Troubleshooting getting krohne output to insight
