AgTalk Home
AgTalk Home
Search Forums | Classifieds (34) | Skins | Language
You are logged in as a guest. ( logon | register )

C099-f9p support Thread
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
ericlit
Posted 3/26/2020 18:50 (#8141197 - in reply to #8140840)
Subject: RE: C099-f9p support Thread


NE Indiana
I have not been successful hardwiring mine to an Insight or a Versa. I was told by a u-blox tech that I needed to be cautious with the voltage levels coming out of my display as they could damage the RTK2 board. The serial pins coming out of the display are 5+ volts and the RTK2 board is a 3.3v TTL. I've been told that the display should be able to decipher the 3.3v TTL but it doesn't seem to. I have a couple voltage shifters that will convert my 3.3v to 5v but have not tried them yet. I'm currently using an HC-06 bluetooth adapter connected to my UART1 Tx/Miso pin and sending the NMEA messages to a Parani SD100 connected to my display and it is working fine. You may need to also hook up the GND pin between the two.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)