|
SW Ohio |
"A solution to this situation is to just mate the connectors fully and then wrap electrical tape around the connection to insure that the two ends stay mated. This is not a very professional approach but seems to work fine." from tedbear
In some situations I think you can remove both the thumb screws and/or nuts and put a small short screw with a nut though both holes at once. Not easy but a little more secure than tape if you are so inclined. The clearance may depend on how the shell covering is made. It's been a while.
Thanks tedbear for your many posts. They are very precise and informative.
Good Luck,
Dave
Edited by L8Bloomer 12/7/2008 22:50
| |
|
What does a null modem cable do? Will I fry my Insight or Mojo?
