|
Kansas City, Mo | I'm trying to move the rear wheels on a 1066. I know there's a lot of posts about this. I've read most of them & tried all the strategies but I can't get either wedge to move on one side. Thought I'd post & see if anyone has some suggestions or can tell what I'm doing wrong. I've been soaking everything with PB blaster for a few days, loosened the center bolt back as far as it will go with a breaker bar & cheater pipe. Smacked the top of the axle with a hammer, used an air hammer on the inner wedge. Drove it a few miles with the bolt loosened, nothing will budge.
 (IH (full).jpg)
 (IH2 (full).jpg)
 (IH3 (full).jpg)
 (IH4 (full).jpg)
Attachments
----------------
 IH (full).jpg (121KB - 11 downloads)
IH2 (full).jpg (121KB - 9 downloads)
IH3 (full).jpg (124KB - 5 downloads)
IH4 (full).jpg (154KB - 9 downloads)
| |
|
Removing IH Rear Wheel Wedges
