|
| I'm sure that EIC allows you to set the flow delays when the card is unloaded, and I would guess you can set them via Apex... so you are overriding what was in the combine. In the sample code that was given to us to program EIC, they showed three "settable parameters" that I would guess are flow delay and start/end pass delays but they were not documented. I've decided that I wasn't going to take time to dink with them until Deere delivered the documentation that was promised when I questioned them about these settings in September. I just don't understand why Deere cannot take one hour and provide a simple document to explain the free-form parameters that cannot be derived from standard object browsing. | |
|
Exporting Yield Data out of Apex
