| yellowfever - 3/8/2021 17:25
Better off to swap the motor or find a different drill press IMO
So with a little more research I found out face mount electric motors are more common than I thought, this is the mount on the motor on the drill press. Does this look somewhat standard? I know it’s hard to say without measurements and I haven’t been able to go look at it yet but are the bolt holes for face mount motors fairly standard? If so it shouldn’t be too big of a deal to get a motor for it and run it off my 220 single phase.
It’s a nice big drill press and I fell the price is pretty good. Not ready to take the jump into a mill just yet but I’ve outgrown my 1/4hp 1/2” drill press
(B4227D76-95C8-479B-B188-2787A73FED68 (full).jpeg)
Attachments ---------------- B4227D76-95C8-479B-B188-2787A73FED68 (full).jpeg (42KB - 35 downloads)
|