Posted 10/18/2020 09:46 (#8551475 - in reply to #8550964) Subject: RE: Auto slack adjuster
I got under it this morning where I could see better. I just checked them with a pry bar, the left side looked to be right at an inch and the right appears to be about 7/8-15/16. That’s just rough measurement, measuring the stroke off the pin. Mind you I only had the tractor breaks set when it happened last night and their are just two parking break chambers on the whole rig. The trailer breaks were released. Most all times we park we leave the trailer charged just to conserve air. We are on flat ground in the dirt so rolling is not an issue. It really felt like it was just normal soft ground and a real heavy load. If you do something for long enough your going to mess up at some point I guess.