|
Center Valley Wisconsin | Before I had a press brake I bend alot of sheets like this. Here I'm bending some 3/16" to make a few metal dumpsters. 5 foot wide sheet,,,, leave one inch uncut,,,then cut 11",,,then leave one inch uncut,,,then cut 11" and so on...
Maybe you all know this but if not it works good.
(IMG_20200928_173706544 (full).jpg)
(IMG_20200928_173700657 (full).jpg)
(IMG_20200928_174119507 (full).jpg)
(IMG_20200928_174152237 (full).jpg)
(IMG_20200928_174041242 (full).jpg)
Attachments ---------------- IMG_20200928_173706544 (full).jpg (114KB - 43 downloads) IMG_20200928_173700657 (full).jpg (112KB - 68 downloads) IMG_20200928_174119507 (full).jpg (136KB - 61 downloads) IMG_20200928_174152237 (full).jpg (40KB - 182 downloads) IMG_20200928_174041242 (full).jpg (54KB - 107 downloads)
| |
|