|
Eastern Iowa | I understand what your saying newag1. However, when we calibrated the tractor, we made several AB lines and drove them one way, turned around and drove back to the other way and we were always driving right down the same wheel tracks. It wasn't until we hooked up the new strip-till machine and were trying to figure out our offsets that we could tell that our guess rows were narrow one pass and wide the next pass, and over and over..... The tractor always drives right down the same tracks so I believe we're got the antenna centered and the roll calibration correct, just that the strip-till consistently hangs roughly an inch or two to the right of center. | |
|
implement offset?
