|
Northwest kansas | Still having problems this morning. I purchased PF90363 which is a serial wire harness. I installed the black wire into pin #23, red wire #23, white #2 into the back of the 2600 monitor. Blue and green are not inserted into the connector. I believe #23 is receive, or from my lack of understanding rx, 22 is transmit, or tx, and white is ground.
Into port a of my fmx is #3 black, #4 red, and #5 white. Believe black is Tx, red is rx, and white is ground.
I am still not getting any gps signal from my 2600 into my fmx.
 (20200522_094138 (full).jpg)
 (20200522_094126 (full).jpg)
 (20200522_094122 (full).jpg)
 (20200522_094056 (full).jpg)
 (20200522_094101 (full).jpg)
 (20200522_094051 (full).jpg)
Attachments
----------------
 20200522_094138 (full).jpg (88KB - 142 downloads)
20200522_094126 (full).jpg (103KB - 126 downloads)
20200522_094122 (full).jpg (100KB - 130 downloads)
20200522_094056 (full).jpg (106KB - 151 downloads)
20200522_094101 (full).jpg (123KB - 138 downloads)
20200522_094051 (full).jpg (114KB - 149 downloads)
| |
|
Starfire pinout and Trimble FMX pinout
