|
NW KS | Try having GGA and VTG selected in the Greenstar menu. You may be able to increase the baud rate to a higher setting and change the output rate to 10hz.
On the fmx match the baud rate the same as the Greenstar, select the proper port, parity (none), data bits (8), stop bits (1). 8-N-1 is a very common serial port setup.
One other thing to check is to make sure the tx pin on one plug goes to the RX pin of the other plug.
Edited by co2shaun 5/21/2020 22:04
| |
|