Near Intersection of I-35 & I-90 Southern Mn. | Hadn't thought of that. If your implement connector out of the back off the tractor has four large pins around the outside and four small pins on the inside this could be quite easy. One pair of the large pins is High Current Power leading to the Gray Deutsch connector at the module. The gray pair is spliced on to the main power for the system. If there is another pair of large pins this is another pair of High Current power pins that can be used. This pair goes to the black two pole connector at the module.
To get power out of the black connector, power must be fed in at the tractor. This is a black 2 pole Deutsch which is usually plugged into a stub that also goes directly to the battery. If that connector were attached to the switched and ground connectors of the 3 pole connector in your tractor, it would go On/Off with the key. The module itself could be run off the gray since that would be very little draw. Your logic reversing relays could get their power which actually engages the Great Plains clutches from the black High Current pair which is key switch controlled. No need to purchase another relay although the 3 pole connectors are a bit spendy themselves.
Edited by tedbear 4/2/2020 18:44
|
Easiest place to get keyed power at the modules on ag leader setup?
