|
East Central Ia | I didn’t think about the clutch logic test failing this way, but it makes perfect sense since it fails when I try to load my configuration with my clutches or relays unplugged.
There is a factory wiring harness to the clutches, it’s a very simple 3 wire harness that takes power from an in cab accessory plug.
It would probably be cleanest to wire a relay into one of the HC power circuits at the tractor.
But there must be a keyed power signal wire to the modules to tell them to “wake up.”
Edited by bleedred 4/2/2020 08:14
| |
|