AgTalk Home
AgTalk Home
Search Forums | Classifieds (142) | Skins | Language
You are logged in as a guest. ( logon | register )

Raven 440 boom cal question
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
tedbear
Posted 6/10/2018 15:23 (#6804618 - in reply to #6804477)
Subject: RE: Raven 440 boom cal question


Southern Minnesota Between Freeborn & Wells
Champ - 6/10/2018 01:50

here is a possible situation.. usually all nozzles are a few degrees off of square or offset to each other, so that their overlapping pattern misses each other. With this it can be an optical illusion when looking at on side verses the other as you will see more pattern on one side than the other because of this design. A quick way to test would be to catch a stationary timed test, but that's not nice to do unless its just water. Have someone look from behind or from ahead and see if they detect a difference in flow while your running. It may look even from their position.


I agree with the above. More than once I've looked at my tips from the driver's seat and think there is a difference which is really just the angle at which I'm viewing the pattern. Pressing button 1 should show the width in inches for boom 1.

Edited by tedbear 6/10/2018 15:24
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)