|
NW IL | I reread and rethought about your original post.
If 2500 is connected directly to the display cable of Integra then my previous suggestions would apply.
If 2500 is connected directly to Intellislope (back on tile plow), I'm not really sure what to suggest.
I'm guessing you updated the Integra at some previous time via usb (say for planter or yield monitor). You are now connecting the Integra to Intellislope for first time since you last updated. The Integra will scan the can bus line and update any modules that need updating. In your case....it updated Intellislope I'm guessing.
Personally.....I would connect the 2500 to Integra (via display cable serial) and verify that the NMEA setting you are sending to Intellislope are still correct.
Baud = 38,400
10 HZ
GGA, VTG, GSV, GSA should all be turned on.
Also make sure 2500 is set to RTK and not WAAS while you are still connected to Integra
You can only change/modify settings on 2500 when it is connected directly to Integra display cable. You can not make changes when it is only connected to Intellislope.
Edited by swenzel 12/7/2017 17:33
| |
|