|
| If your needing to get planting, try doing your roll offset with the planter instead of the tractor. Get on a AB line, mark the middle of the planter, then come back over the line the opposite direction, put in your roll cal value and double check until its good. Its not the right way to do it but at this point a lot of people just want to get to planting. You will have to re-roll cal the tractor after planting season. If your rows are too wide after this then narrow up your implement width. I have had to do this to get people going. | |
|
trouble with fmx / fm1000 and trim or swath width
