|
southern mn | You can set the offset by going into guidance menu and scroll down to select stored ab. When the first one comes up, select that(that will be your current ab line). Then you can reset your implement offset at that point. One thing I found out the other day was to adjust my ant/imp offset. I had it set for 204 inches for my pull type planter which is to the planter bar. I dropped it down to 150 inches because I felt it was to slow reacting to slopes and not keeping my guess row accurate. From what I can see now, it is keeping my guess row right where it should be. I think I'll have this EZ steer thing down pat by the end of planting season. Been a definite learning process on CR2 west of you. | |
|
ez-steer offset... [part two
