Great Southern, Western Australia | So at least with east-west lines it shouldn't matter where you set the A point, as long as the heading is the same? Maybe I will just run all our runlines east-west!!
The other question is, does the method of runline creation follow the console or the reciever? I am assuming the console as it contains the processor doing the calculations? So if I had a JD 2600 reciving a signal from a MOJO RTK it will still create runlines using the JD method? Similarly, if I had a Raven Viper Pro receiving signal from a JD Starfire receiver it would create runlines using the Raven (non-JD) method?
Edited by snowcone 1/25/2011 21:03
|
Deere vs Trimble AB lines
