|
| I had some time today to try out your help. I do have a Raven motorized control in the product line and was using the system with a Raven 440 in the other tractor with an EZ-boom.
In this tractor, I uncoupled the cable where the console cable,115-0171-085 is coupled to the flow cable 115-0171-055. That connection is in the cab. I put a VOM on pins 3 and 4 and initially had no voltage, when I clicked the master on with all sections on, it jumped to 13 v. No change in reading occurred when I held the Increase or Decrease. When I turned the master off I still had 13v. It stayed that way for a minute or so and then went back to zero.
When liquid is flowing the master does open and close the 3 solenoids, but I presume that is part of the section control.
I do have another Field IQ system with rate and section control and another master switch, I will try them out on the system to see if that is the problem.
Thanks
Edited by gw73 7/1/2024 18:12
| |
|
Field IQ Rate
