|
n.c.iowa | Also to add there are springs just for the divider tips as well, there are 1/2" bolts that go to springs inside the main dividers , turn them so that the dividers run about 1-1/2" above the ground when in operation.
I've had better luck using a impact wrench on them because of their location, there is jam nut on them as well.
When you adjust those springs, yhey are spec'd to be carry a big azz divider, so you wull not have any bouncy-bouncy with the little divider .
So you are basically adjusting the bottom stop now with those springs.
Edited by johnny skeptical 10/14/2021 09:39
| |
|
Adjusting 1020 head for smaller row divider
