AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Adjusting 1020 head for smaller row divider
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Expensive Hobby
Posted 10/14/2021 09:34 (#9268358 - in reply to #9268239)
Subject: RE: Adjusting 1020 head for smaller row divider


Missouri
Eww. Those look like a poor design. Should be flat on the bottom coming out of the square tubing instead of sticking down lower I'd say....

I guess you could take some tension out of the springs on each end maybe so the row divider can run higher relative to the cutterbar. Not sure what else there is to adjust that would help. I don't have a pic of mine, but what I did was just bought the white poly ends from case and attached them to a short piece of square tubing. Works fine unless beans are down, and then I can put the big ones back on if I have to. I think there are old threads on here with pics which is where I got the idea.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)