Posted 9/13/2021 10:42 (#9217967 - in reply to #9217741) Subject: RE: Agleader clutch module
Ewfflyer - 9/13/2021 08:03
I set implement up for 2. Tried every option I know to get into data, but how do I modify the module?
It's been a while since I was into this stuff very deep, but I believe the clutch configuration (# sections, rows per section, row location) is part of the implement profile on the AgLeader display. Maybe you already knew that, but it looks like your pics are all of diagnostic stuff... so wondering if you're just trying to go in through the wrong menu and not finding what you need. It may be easier to create a new implement profile than trying to add clutch control into a prexisting profile that didn't have it enabled. I know I scratched my head for a ridiculous length of time trying to figure out how to get seed tube monitoring working on my planter this spring, and I think I eventually had to create a new implement from scratch to get it to show up.
As Tedbear mentions, make sure you have relays wired in the proper polarity and everything connected and powered up before you try to configure the clutch module through the display.