Near Intersection of I-35 & I-90 Southern Mn. | I don’t like the large connector on the clutch module. I have broken the tabs off of more than one trying to release them to remove the harness. I believe the problem is that the outer case of the module does not allow enough clearance for the connector to drop in like it should. This may be why yours was not fully mated. Try to avoid removing it if possible. If it must be removed try to push it in even more before trying to push in on the tabs.
Hopefully the module passes the clutch (relay) detect step now.
Edited by tedbear 9/14/2021 06:47
|
Agleader clutch module
