|
NW IA | There’s some helpful tips in this manual.... https://www.mountsmachinery.com.au/wp-content/uploads/Field-IQ-Manua...
“ * Some Field IQ Info states that this should be entered as the Minimum Flow that the Flow Meter is capable of reading, which would explain why this setting is under Feedback Setup. I have verified that this is not the case. The Minimum Override Speed setting still doesn’t work, so you will have to enter a Minimum Flow rate in here, to keep your nozzles from going back to a dribble as you slow down. ie: 02AIXR Nozzles = 0.46lpm @ 1bar. Times this by the number of nozzles on your machine and you will have a LPM reading, which will keep your minimum Boom Pressure at 1Bar.“
Also:
“ Lock in Last Position – This will keep the Valve in the position it was in when just before the last Section was shut off. This will help the system return to operating pressure quickly, but may result in Manifold pressure spikes as the sections are all shut off.
Normally select Lock in Last Position, unless pressure spikes are observed.”
| |
|