|
Edgeley, Saskatchewan | Thanks John.
I never take the mass flow sensor out but it does work fine most of the times except every so many minutes but it does not seem at regular intervals. But I will check the conection tomorow to to make sure that does not happen. I think you are right because I had one of the lines set on flow/hour and when average would come on it would go to zero flow.
What do the mouse do to the sensor?
What i don't understand is that 95% of the time it shows a yield that is very accurate. If I fill my grain trailer complely full it holds 1170 bu and that is very close to the monitor number so something can't be so wrong.
I know what you mean about gummy stuff, it can happen in peas with dirt and weeds ( similar to soy) but canola is dry 50lbs/bu 35bpa crop so it does not gum up The plate is clean and in good condition.
Still don't know why it did not associate the yield to GPS data.
I am going to check the conexions.
Any other ideas?
anybody else?
Francksaskfarmer | |
|
Ag leadr pf 3000 problem
