|
SE NE | Row units
- make the front pin greasable. Replacing the bushings and buying new pins is damn expensive.
- Gauge wheel spindle doesn't take grease very well. and hard to get to front gang
- Plastic gauge wheel rims are a joke. The black metal rims flex a little to much. Ive been using kinze rims lately.
- Seed boot bolt holes wear out to soon. Not sure how to fix this, maybe a bushing?
- Gauge wheel adjustment lever gets bowed out and sloppy. Which affects seed placement. Someone on here made a hardened shim for it. :)
- That little bolt/screw that holds the metal seed tube into the boot just gets rusted in. And you have to take that off to get the seed boot off.
- The electronic rate controllers need to have a more common electrical plug in on the motor, Maybe a weather pak connector.
- Have the same rims on the front of the drill as the back. My 20ft 1590 has 6 bolt rims on the back and 8 bolt rims on the front. So I have to carry 2 spares around. And at 450 bucks a tire plus the rim that gets expensive.
Just my .02 | |
|
ATTN. DEERE SEEDING GROUP
