I have the controller working...sort of. 

I'm using a 700 with  channel 1 running the augers in the bed I posted pics of on MT some time back.   Channel 2 is running the apron chain.  I have the same speed encoders on both shafts.  Both are producing readings.  Both (DJ) valves are operating. I can speed up and slow down the motors using "Man" and "Inc" "Dec" This is where I'm getting confused.  Channel 1 is workign exactly like it should. Channel 2 works like it should manually, however the speed reading is whacked.  When you slow the shaft down (I can see the shaft....my eye says that it is in fact slowing down,) the rate on the display increases.  When you speed it up, (again, my eye says that it is in fact speeding up) the rate on the display decreases.   It seems like the controller has a 1/x button pressed somewhere or something.

Controller is rev G, my manual is rev B, if that by chance makes any difference.  

Any wise people have any idea what I'm missing here?