|
| Having a CAN communication problem with a steer command system hooked to a 2016 JD 8320R. This is a first time install in this tractor. I have checked all the usual suspects. Proper unlocks, ISO bus IBBC connector on the tractor has been replaced, verified wheel angle sensor and valve calibration on the JD side, disabled precision ag setting in the 4600, ohm'd out my harnessing in between the steer command and the 9 pin amp. Any other ideas or experiences out there? The 4600 shows a new controller related to navigation as soon as the steer command powers up. On the steer command side the vehicle and controller config is correct but it is getting no communication with the "Actuator". | |
|