|
Northeast Nebraska | Have a 2013 1790 seedstar xp 16/31, 2630 monitor with section control unlocked. After turning around on the endrows, on the guidance/mapping screen it shows the planter being jack knifed with the tractor and takes atleast 150ft for the planter to follow behind the tractor again on the screen. This screws up the coverage maps and the shut-offs. The offset measurements are input correctly for tractor and planter. Gps input into 2630 is from agleader 6500 via serial port. 2630 has gps and ground speed. It's like the 2630 isn't making the correct calculations for the planter following the tractor on curves. Have good gps signal. What do I need to do? The last picture is just to show what it is doing to the point rows. The third picture is showing what the screen is doing after turning and the tractor and planter are physically in a straight line, on the screen the planter does not fully pivot around and follow behind the tractor until 150 ft out into the field.
Edited by baier91 4/25/2021 15:36
 (PXL_20210425_125649195.MP (full).jpg)
 (PXL_20210425_125653476.MP (full).jpg)
 (PXL_20210425_125604253.MP (full).jpg)
 (PXL_20210425_125451574 (full).jpg)
Attachments
----------------
 PXL_20210425_125649195.MP (full).jpg (123KB - 196 downloads)
PXL_20210425_125653476.MP (full).jpg (128KB - 213 downloads)
PXL_20210425_125604253.MP (full).jpg (106KB - 204 downloads)
PXL_20210425_125451574 (full).jpg (142KB - 196 downloads)
| |
|
problems with a deere 2630 fed gps by agleader 6500 while planting
