|
Southern Illinois | Not sure if you got this going or not but also on the 372 set the base ID to 255. This should let it take any base corrections. Otherwise depending on the Trimble firmware the base ID must match on both RTCM or CMR or it won't use the corrections. Again seems to depend on firmware.
Also a few years ago there was an issue where the firmware on the NAV2 actually made a difference. For a while if it had a NAV and you input in port C it would show data but not allow use of it. The data had to come in through port B and only as a CMR radio protocol. After a while when the CNH tractors got machine updates then portC worked normal again. | |
|