I have an opportunity to remove some boards from a building.  The tops of the boards can just be broken loose.  The boards are about 9 feet long and nailed at the bottom and middle. 

I should be able to get a 9" sawzall blade between the 2x4 and the board to cut the nails holding it in the middle and I could just take a circular saw and cut boards off at the bottom.

It's the middle that has to be separated from the 2x4.

I've used Milwaukee and Lenox blades, neither has been satisfactory.  I need a blade that will hold up to bending a little and not dull after only a few nails.

I know that I need a fine tooth so it will cut nails and not dig into the wood.

(sawzall (full).JPG)

sawzall (full).JPG (36KB - 56 downloads)