AgTalk Home
AgTalk Home
Search Forums | Classifieds (20) | Skins | Language
You are logged in as a guest. ( logon | register )

5130 moisture not reading
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
torn
Posted 10/12/2020 07:21 (#8541892 - in reply to #8541731)
Subject: RE: 5130 moisture not reading


roaming
Trooper - 10/12/2020 04:45

Auger appears not to be turning, cleaned all the connectors, cleaned dirt and dust, put 12 volts directly to motor, then it runs good. Adjusted proximity switch like was suggested below but no go. Fuse is good. Reads moisture on the monitor but still had beans In the auger after running corn. When the moisture reading changes it is very little. Anymore suggestions? Thanks

Does the motor cycle correctly when you manually test it by putting something in front of the proximity switch while the separator is running?
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)